Matech GT3

[07XL0027]

I do love that RED!

That's why you need a 2018 Heritage Edition. I believe it is the same red.


Sent from my iPhone using Tapatalk

 

[RickH]

That has got to be the prettiest girl at the dance.

 

[nz05gt]

Stunning selection of cars beautifully presented as always

 

[BBRGT]

Looking good and very stable into festival. Making all the right sounds too!

Thanks , Jeff , just had some brake balance issues which we have sorted out , it turns in really nice and the traction off corners is very good.
Gearing is good for the Festival configuration but we will have to change it to run without the Festival .
Motor pulls nicely to 7500 rpm and the flat shift works really nice.

 

[PL510*Jeff]

Thanks Jeff , I will get in touch with you when we are going to do our first test , most likely at one of the Prodrive days at Portland

Thanks.

 

[fjpikul]

I just love that RED. Nice job.

 

[PL510*Jeff]

Wonderfully close, Looking very good.

 

[Sinovac]

It looks much too nice to be a race car. Nice job.

 

[BBRGT]

Clean......

Thanks ,it was pretty dirty from 3 years of racing , the centre tunnel had accumulated a fair amount of rubber , oil and dirt .

 

[Xcentric]

What are your plans for this car when it's completed?

 

[BBRGT]

Absolutely beautiful! Would love to see it at rally 12.

Thinking about it , would also like to bring the street GT .

 

[soroush]

looks amazing !

 

[BBRGT]

Some photos of the floor panels removed





The centre tunnel with the fuel cell removed

 

[BBRGT]

Starting to clean up the engine compartment , replacing the fuel pumps , coolant hoses , and some of the oil lines .



Air jacks need rebuilding



Cage painting turned out nice



Test fit the right side rocker panel



Fuel cell is arriving tomorrow , once it's installed we can start mounting the remaining body panels .

Another car we have in the shop right now

 

[PL510*Jeff]

You have obviously been very busy. Unreal amount of custom part fabrication. Looking forward to seeing the finished product and it on the track. Will you take it over to the new course on Vancouver Island?

There's a 2nd new track in s.e. B.C., Area 27, south of Penticton. Should be open shortly. I stopped there last month on 2nd day of paving.

Looks to be a Racers race track, rather than a car club cc track. Hope to visit the Island track and see friends in Victoria right after I get back from Rally 11.

 

[BBRGT]

Rear diffuser installed

 

[GT101]

Am I right in thinking the floor panels on the Matech cars are flat? - the ones in the road car are dimpled and made from two layers of hydro formed aluminium sheet.

 

[BBRGT]

What are your plans for this car when it's completed?

I will race it in the Pacific Northwest and run some SVRA events

 

[BBRGT]

Engine photo , think I am going to change the coil covers

 

[shesgotlegs]

Great read! Thanks for sharing.