Show Me Your Speedhut Replacement

[Ed Sims]

Where did you get that carbon fiber switch cover from?

I think it was from Kip Ewing.

 

[Simon]

I have Ed Sims' bezel but in brushed finish.

 

[MiamiGT]

My Speed gauge started failing about 3 months ago, on and off...Took the car for service and the mechanic asked me if I keep the battery on a tender, I said yes. He said the battery is almost done, it doesn't fail on you because the tender keeps it charged but the gauge can tell is not sending the proper voltage at some point and time. It made sense, he replaced the battery and it started working right away. All good now.

 

[MTV8]

Here is my setup. I feel like the shift lights are a must have option.

 

[Shark01]

Here is my setup. I feel like the shift lights are a must have option.

View attachment 71045

Where did you get the carbon fiber panel?

 

[roketman]

Here is my setup. I feel like the shift lights are a must have option.

View attachment 71045

Looks awesome! Nicely done

 

[MTV8]

Where did you get the carbon fiber panel?

I got it from a forum member that has not been active here for some time now. Seems like it should be pretty easy for a carbon fiber shop to replicate.

 

[wmjim]

I just replaced my gauges this week. I'm not sure why, but I had near impossible clearance issues with the new Speed Hut small center gauges. There was zero clearance between the gauge itself and the odometer/warning light circuit board unit. I ended up making 5/8" wide "C" collars for under the threaded clamping rings so the rings stayed above that odometer unit.

 

[Bbhaynes]

Here are the Speedhut gauges Nth Moto just did in my car. They even did a nice little logo on there for me. Also had the boost gauge read up to 30psi now too. Turned out really good.

https://flic.kr/p/2qJguSR

https://flic.kr/p/2qJgAfU

https://flic.kr/p/2qJaPk7

https://flic.kr/p/2qJfisv

 

[nota4re]

Also had the boost gauge read up to 30psi now too.

The gauges look great. I'm assuming then that the boost gauge has been direct wired to its own MAP sensor or is the 30psi scale just for better aesthetics?

 

[Bbhaynes]

The gauges look great. I'm assuming then that the boost gauge has been direct wired to its own MAP sensor or is the 30psi scale just for better aesthetics?

Yeah it is direct wired with its own sensor with the Motec so we get the most accurate reading.