Wow, thanks for the analysis. Might still be a good idea for 1/4 mile, or 1 mile runs.
So, I guess some solutions to the problem might be, change ic coolant to water only, additional heat exchanger, lower boost(less heat), fluid inter cooling-either nitrous or water/alcohol, cooler running fuel-e85, fan in the engine compartment, etc.
Out of all of the ideas, I like water injection the most. Usually used for detonation suppression, but in this case its primary purpose would be, to cool the charge air. Water has a very high specific heat and would draw mucho heat out of the charge air and engine. No need to use alcohol and be concerned about it's reaction with aluminum. There are many kits available that read boost and only begin to spray at a certain boost pressure. Could also be temperature and boost activated. What do you think?