Use of Gearshift Lever Aligner Tool


S

SaskGT

GT Owner
Dec 24, 2013
47
I recently purchased a clutch aligner on ebay and it came with the OTC 308-602 tool.
Checked the service manual, my local Ford dealer and the internet on how to use this tool, but no luck.
Could someone tell me how to use this device or were I could find instructions.
Thanks for the help.
 
Give the GT Guy(S) a call. Pretty sure they would know.


SaskGT said:
I recently purchased a clutch aligner on ebay and it came with the OTC 308-602 tool.
Checked the service manual, my local Ford dealer and the internet on how to use this tool, but no luck.
Could someone tell me how to use this device or were I could find instructions.
Thanks for the help.
Click to expand...
 
The tool is intended to hold the gear shift lever in a static neutral location so that the shifter cables may be adjusted. To use, you need to remove the shifter ball and then the boot and slip the tool over the shaft of the shifter. The adjustment process is described in detail on page 308-00-14 of the 2006 Service Manual.
 
nota4re said:
The tool is intended to hold the gear shift lever in a static neutral location so that the shifter cables may be adjusted. To use, you need to remove the shifter ball and then the boot and slip the tool over the shaft of the shifter. The adjustment process is described in detail on page 308-00-14 of the 2006 Service Manual.
Click to expand...

Thanks for the help.
Joe
 
PM sent
 
Stormkitty,
You sure do get around!
Love ya buddy!
 
You must log in or register to reply here.

Top Bottom