One of my favorite features on the Z06 & ZR1 Corvettes is the moulded fender extension on the trailing edge of the rear fender.
I'd like to have something similar for my GT... but most I've seen are simply flat pieces of plastic that remind me of an old school mudflap from the 60s.
Just can't go there on my car.
The cost for the GM part is about 45.00 per side, but I'm not sure the body contours are close enough to look correct...
Anybody our there in GT land have a better idea for me?
E/Pockets, I know you'll have some good thoughts on this subject.
mardyn
I know, terrible picture below, but that's all I could find on short notice.
I'd like to have something similar for my GT... but most I've seen are simply flat pieces of plastic that remind me of an old school mudflap from the 60s.
Just can't go there on my car.
The cost for the GM part is about 45.00 per side, but I'm not sure the body contours are close enough to look correct...
Anybody our there in GT land have a better idea for me?
E/Pockets, I know you'll have some good thoughts on this subject.
mardyn
I know, terrible picture below, but that's all I could find on short notice.