Search results

Troublemaker

Winning.

In profile, she's a stunner, OK from the front, ugh from the back. Interior is, well, different. Finally a couple of (so, so) options for the seat. Why they can't put a seat in these things with a proper lower bolster is beyond me. My Z06 isn't in any immediate danger of being replaced...

Probably best.

With respect, I think you are in the minority Freddy.

http://www.youtube.com/watch?v=7tZPj7Ebh0o

Out of FGT calendars or out of SVT 'add-on' calendars?

Ha! I figured you fellas would like them. Busted out my severe carpentry skills.

This ^ The RaceRamps RR-Rack4 helpers lift the end of the stock HD-9 steel ramps 3". On my HD-9's, I was concerned that was too high, meaning it would hyper-extend the inboard side of the ramp. You can simply replace the OE ramps with RaceRamps full setup, but then you are storing them...

It reminds me of Mercedes Black Series - just not done as well (the sill integration in particular). Meh.

Nice to see the GT being so well regarded there (in spite of Clarkson's early whining). That Quicksilver sure is pretty.

Yummy

Good reminder. I used my Z06 as the test car with the bridge jacks at opposite ends.. I just barely nicked the rear jack so I wised up and pushed it forward before driving the GT on. The round pads are drop in. Once removed, the extensions slide most of the way back in. You can see them...

You're very welcome. They look like foot pedals but are hand actuated. Lift one side, release on the other. There is a manual safety that must be cleared before the bridge will lower. Pretty slick.

Ah, I see what you did there. I thought to replace the whole ramp. On my lifts, I don't think I could use their 'pre-ramps' at 3" step height. My ghetto ramps are 1.5" and that's about all the higher mine will allow.

I like the Race Ramps. Better than my ghetto wood pre-ramps :) Their prices make me want to start a competing business. Their margins must be huge. Did you buy the version with the 3" drop-in lip? http://www.raceramps.com/hook-nosed-rack-ramp-20x5.aspx

Not yet, but I will. It looks like a great add-on. Any pics? Anytime Jason.

I've had my Bendpak HD-9XW four post lift for awhile now, but hadn't installed any bridge jack or jacking tray setup to allow me to get the wheels off my car/truck while on the lift. I was swapping winter wheels/tires recently on my wife's car - one at a time - using my trusty floor jack and...

Your daughter has apparently not driven with you Bill. J/K Great gift.

This little bad boy does just fine for the lift air locks - needs maybe 40psi to unlock. http://www.sears.com/craftsman-3-gallon-horizontal-air-compressor-with-hose/p-00915310000P?prdNo=2&blockNo=2&blockType=G2 Yes, the standard ramps. See pic below - I made pre-ramps a while back for low...