Control arm bushing


Anybody here replaced the bushings like this or has everyone bought new control arms? I'm having some wear just as a few from this thread.
 
Ford clearly did not use the same design for control arms and bushings that they used on my 1965 Mustang. Fifteen minutes and $29.95 later they were all replaced.
 
Uh, was your 1965 Mustang designed to safely motor along at 200 mph?

Apples vs. oranges.
 
looks to me like the rubber dust/water seal has perished. if the joint does not have any wear , then just replace the cover, should be held in with a c clip or similar, just source a seal from something similar..
 
These rubber boots are very thin compared to those used on other parts of the suspension. They are actually translucent when new.
 
You must log in or register to reply here.

Top Bottom