Turn signal out!


Scooter

Scooter

GT Owner
Mark II Lifetime
Apr 15, 2009
168
Guys some of you may remember I pulled the front clip last year to replace a refrigerant line..after completing the install I realized my front drivers turn signal stopped working. I'm positive it worked when I tested it just before I closed up the wheel well...It has not worked since as I just didn't feel like pulling the whole front end apart again and now I'm scheduled to drive in the August 4th autobahn in Joliet IL and they want that signal working. Has anyone had problems with turn signals?
Thanks!
 
Last edited:
http://www.fordgtforum.com/forums/s...n-Left-(Driver-Side)-Front-Headlight-Assembly

Read through this thread. Sometimes a slap is all it takes.
 
FENZO said:
http://www.fordgtforum.com/forums/s...n-Left-(Driver-Side)-Front-Headlight-Assembly

Read through this thread. Sometimes a slap is all it takes.
Click to expand...

Works only for a brief moment. Need to pull that front wheel well liner and clean those leads.


Sent from my iPad using Tapatalk HD
 
Worked for a couple years for me.
 
Thanks, I will give it a good smacking in the morning! Glad to hear (if needed) I wont have to pull the wheel housing off!
 
Pull the bulb out and you will notice that the wire contacts will be dark gray/black. Scrape these contacts gently with the edge of an Exacto knife or razor blade. A fine grain emery cloth would also work to remove the oxidation. After cleaning, put a generous amount of dielectric grease. DON'T skip this step unless you relish removing the fender liner! I've had to do quite a few now, never had to re-do one.
 
Last edited:
Wow after dealing with this for almost two years I gave it a love tap this morning and she's working great now!
 
I had one side go out just after the fender liner was removed and reinstalled. The other side just went out recently. At least now they are back to being symmetrical.
 
I need to pull it apart..the love tap was short lived
 
Scooter, sending you a PM. Call me. Dr. Frank

I have a long post here about headlights and replacing the turn signal bulb without pulling the fender liner.
 
Funny mine just went out today. Tapped it all good lol
 
Found good thread on this forum regarding this problem I searched "turn signal"

I took a few pictures!
Good thing I didn't work out today..its not easy squeezing your arm in there!
photo 1(1).JPGphoto 2.JPGphoto(13).JPG
 
fjpikul said:
Scooter, sending you a PM. Call me. Dr. Frank

I have a long post here about headlights and replacing the turn signal bulb without pulling the fender liner.
Click to expand...

Got a link, doc?
 
 
 
bonehead said:
Link doesn't work
Click to expand...
If you go to the 2nd post on this thread that is the link I used
 
Scooter said:
If you go to the 2nd post on this thread that is the link I used
Click to expand...

Ok got it. I already knew of that thread and posted in it a few months ago.
What's still not clear to me is if the passenger side bulb can be accessed via Dr. Frank's method (dropping front airdam, moving washer reservoir, reaching up to get bulb) or just the driver's side??
 
bonehead said:
Ok got it. I already knew of that thread and posted in it a few months ago.
What's still not clear to me is if the passenger side bulb can be accessed via Dr. Frank's method (dropping front airdam, moving washer reservoir, reaching up to get bulb) or just the driver's side??
Click to expand...


yes - but on pass side there is no washer tank to navigate... much easier.
 
MAD IN NC said:
yes - but on pass side there is no washer tank to navigate... much easier.
Click to expand...

OK so passenger side sounds easier. As a reference to others on the drivers side I didn't even move the washer tank but I did think it was a miracle when I got the darn thing turned counter clockwise and off!
 
Dr Frank I would like to speak to you about headlights. my left side headlight has gone dark on me. the dealer says if it is not a loose wire there is no bulb replacement and I have to purchase the whole assembly for $4,000. is there an alternative?
 
You must log in or register to reply here.

Top Bottom