Search results

I believe aftermarket tuners leave some indication the car was tuned by a non OEM method. Have you tried having Ford reload the stock tune?

I assume the original owner never filed a claim with the insurance company, and therefore retained their "clean" title.

https://www.erniesauto.net/details/used-2006-ford-gt/95702537

No. I reported the issue with the hose several months back.

I did install the hose last summer, and this year did note the hose is a little greasy and leaves a black residue on rags when wiped. I did provide this feedback to the suppliers. I have a spare new OEM hose, but was waiting to see if anything evolved on the replacement hoses, as new OEMs...

Very typical for the rear lower control arm and link end seals to be split from age. The GT garage or GT101 can supply replacement seals, which are not available from Ford, seperate from the component. Oil pump belt, should be changed, if original. Battery ground cable in front trunk should...

You have to take the radio out, which uses a pair DIN radio removal slides. There is a thread that includes info on the tool and which wire to tap for power. https://www.fordgtforum.com/forums/threads/bluetooth-adapters-for-the-mac-radio.33784/page-2 Lots of blue tape on the console area, and...

I read somewhere on this forum that M7049A/TL Satin Silver Metallic Is the paint code for the console. I have used this paint code to touch up some small chips in my console with a good results.

Here is a link to a long thread of the axle bolt replacement program. The first replacement bolt kits, from Ford, became available 12/2007. I would assume you do not have the final revision, since your paperwork also has the 12/2007 date...

A car, very similar to the appraised car, just showed up on Coparts. Red 2005 vin 1706, 33k miles, CA car, and what appears to be a raised driver's seat. The 275K-300k may be overpriced now. Could be a different car, but very close in spec and mods...

I would agree the estimate seems low. At Barrett Jackson Houston, last October, a rebuilt titled GT sold for $275K before fees.

You can use google to search only fordgtforum.com, by tagging your search with site:fordgtforum.com. Lots of threads discussing the Continental ContiTech "SilentSync" Y-720. I am running this belt.

The screens just have six screws thru the radiator cover. Two on a each side and two on the bottom. The screws thru the side fender apron are for the overall radiator cover, which the two screens bolt into. Sure looks like a fastener is missing from that mount.

I would try and see what you can accomplish through removing the radiator cover vent screens. Probably get some access from below, by dropping front pan, etc.. If you need full access, yes you need to remove the front cover and radiator cover. For the front cover removal/install it is easier...

Drilled rotors generally do crack, if you drive them hard. Slotted rotors are better IMO for track duty. A two piece rotor will save a little rotating mass, which in competition can be an edge. Below is a general document(Originally Porsche data I think) on assessing rotor cracks.

My O6 also had a noise that sounded like something loose rattling when you closed the door hard. I removed the door panel to find the rattle, and found it was the flaps in the air equalizer vent in the door. There was nothing wrong with the flaps/vent, it just makes a little noise when the...

If you have two programmed keys, the procedure to add additional keys is in the owner's manual. If you only have one programmed key, you can use forscan software or bring it to the dealer. If you opt for forscan, you must have two good keys(does not matter if they are programmed for your...

I believe this is the part number for the three strut/support rods: 5G7Z-17C972-AC. In most cases the rods can be adjusted, or the rod foot bent flat again, to cure a frowned front splitter.

The three center support rods(one in each of the 06 grill vertices) are also slotted where they bolt to the back of the front bumper support. This allows some up/down adjustment of the center section of the splitter. On the 06 models this adjustment is easy, as the grill does not block access...

Some parts sites say the same canister is also used on the 2004 Ranger.