M2K Motorsports Custom Air Induction!

[Wwabbit]

The custom exhaust looks very nice and it leaves the back end open more. I bet it has nice subtle tone.

 

[FBA]

Can I buy the intake setup from you?

 

[MarkH]

Can I buy the intake setup from you?

Absolutely!! All we need to know is what has been upgraded already on your GT.

 

[FBA]

Sent you a PM and spoke to Blake, who I sent a detailed e-mail to minutes ago!

 

[PeteK]

Mark: I have a favor to ask. I noted that the GT in the pictures is up on a 2-post lift. I want to get a 2-poster to replace a 4-poster I have now. Some (maybe most?) 2-posters don't quite clear or position correctly for picking up the GT on its jack points. Does the machine in the pictures do this, or do you have to do some jacking around to get it up on the lift? It also appears that the posts of the lift in the pictures are angled (turned) away 45 degrees or so from the usual orientation. Is that to allow the doors to open while on the lift? I'm open to other recommendations too.

 

[MarkH]

Mark: I have a favor to ask. I noted that the GT in the pictures is up on a 2-post lift. I want to get a 2-poster to replace a 4-poster I have now. Some (maybe most?) 2-posters don't quite clear or position correctly for picking up the GT on its jack points. Does the machine in the pictures do this, or do you have to do some jacking around to get it up on the lift? It also appears that the posts of the lift in the pictures are angled (turned) away 45 degrees or so from the usual orientation. Is that to allow the doors to open while on the lift? I'm open to other recommendations too.

Yes our lifts will pick up a GT on their jacking points but the car must be perfectly centered. The posts are set 144in apart in the wide configuration. They are also set backwards. Short arms go toward the back and the long arms go toward the front. They are also at an angle to get the doors open.

If you are interested I can supply the model and part number of the lift we use.

Thanks