Who has the "GT" emblem that attached to rear panel?

[Special K]

I put the badge on because the wheel center caps were the only Ford GT logos on my car. I always notice people going to this badge to figure out what make/model my car is!

 

[Exoticare]

For those of you that have/like this badge on the car, I have special versions of FGT floor mats with the same logo and can match your color combinations. A very nice touch for the aging rubber mats that are de-laminating into the floor pans...

PM for details

 

[MJSFRX]

I have three. 79$ each

How would I purchase. Thx

 

[Iconic GT]

I badged mine as well. went to FORD and purchased a Race Red touch up kit and painted mine to match the Red calipers. Nice lil addition....

 

[franimal007]

I have three. 79$ each

I am interested

 

[franimal007]

I have one for my car. What is the best way to mount it, being pot metal, you cannot tap it. Also, what about some sort of felt to protect the mesh screen?

 

[Bilt2run]

On its way

 

[Iconic GT]

I have one for my car. What is the best way to mount it, being pot metal, you cannot tap it. Also, what about some sort of felt to protect the mesh screen?

it comes with two,post and two clips. Rich Brooks and I put mine on in Atlanta. The clips will not tighten down all he way... a little dab of the red high heat permatex solved this issue.

 

[Special K]

it comes with two,post and two clips. Rich Brooks and I put mine on in Atlanta. The clips will not tighten down all he way... a little dab of the red high heat permatex solved this issue.

I used a small deep socket (like a 11/32”) with a small mallet to tap the clips on tight. Still holding fast.

 

[franimal007]

I have 2 and neither came with clips, I was able to shorten the post and I was thinking of clips to hold it on, but would like it to not ruin the mesh.

 

[greekboy]

are there any left?

 

[ottawa1967]

https://www.ebay.com/itm/Ford-XW-GT-Falcon-Grille-Badge-Fitting-Clips-emblem-grill/271651720897?hash=item3f3fb44ec1:g:ep8AAOSwTcRdRHsA

 

[centerpunch]

I always thought this might also be a good choice, I think it's old enough to be metal instead of plastic.

https://www.ebay.com/itm/NOS-Ford-1967-1968-Mustang-Cyclone-GT-Ornament-Fender-Emblem-C7gy-16098-b1/292961369614

 

[franimal007]

I ordered this one, I wanted to add a little color to it. It has not come in yet, but I will add a picture once installed...I hope I like it?

GT FORD Grille Badge , Chrome , BRAND NEW , for XW Ford Falcon 351 GS Grill | eBay

Quality you won't find anywhere else!

www.ebay.com

 

[Bilt2run]

Hello I just saw the request about the emblems I have they are very nice and come with a little backing plate and push nuts they go through the meshno problem without damaging.. I will post up a few pics and a way to pay if you like
I ordered extras because the shipping from Australia is killer so just trying to cover the cost on it

 

[nautoncall]

Please do.

 

[Bilt2run]

I have one remaining

 

[Bilt2run]

 

[Bilt2run]

 

[Specracer]

Some have changed the orange to a different color, like car color.