exhaust messurements needed


Jason Watt

NFGT Owner
Mark II Lifetime
Oct 14, 2005
1,215
Copenhagen, Denmark
Hi there.
My car is in peaces and when going back together it will get the bumper delete job.
I have an Accufab x-pipe and when cutting it down in lenght I would like to add some tips to it, but I'm not sure there is enough room due to the shape of the tubes.
Would some one with a bumper delete exhaust like in the link below please messure the length from the centerline om the mounting flange to the end of the top of the tips??
:thumbsup

http://www.hellotrade.com/cool-tech-clarinda/ford-gt-bumper-delete-exhaust.html
 
Aug 25, 2006
4,436
Hello

Tips such as shown in the picture can be used however you will have to fish month the upper portion of the tip and then hand fit them; tack them in place and then lift the assembly out and complete the perimeter weld.

Takes care

Shadowman
 

Jason Watt

NFGT Owner
Mark II Lifetime
Oct 14, 2005
1,215
Copenhagen, Denmark
I'm now plannning to have the exhaust made from scratch and the tips I'll use are bigger than the ones in the link.
So messurements would be grately appriciated.
 
Aug 25, 2006
4,436
You shared that you were using an AccuFab X pipe; did I miss something?

Shadowman
 

Jason Watt

NFGT Owner
Mark II Lifetime
Oct 14, 2005
1,215
Copenhagen, Denmark
You're right Bill but since my first post I decided to make a new exhaust :wink
But still would like to get info as asked in the first post.

Thanks
 
Last edited: