I finally got these anodized and engraved. We did these a few months ago and ended up using the prototypes for a custom GT3 Cup Car project car that was going to be in a show.
Harder to do that it looks, takes awhile to run and flip. This is a very thin billet cap that is held on with double stick tape. Did not want to compromise the integrity of the Camlock itself or remove the screw. These will fit just about any camlock with the 2" diameter raised circle center section, Crow, Diest, Older Simpson and others. If you Have a Porsche with these camlocks, I can do those as well.
What do you think?, If there is enough interest I can run some off. Pretty inexpensive for a custom touch.
Harder to do that it looks, takes awhile to run and flip. This is a very thin billet cap that is held on with double stick tape. Did not want to compromise the integrity of the Camlock itself or remove the screw. These will fit just about any camlock with the 2" diameter raised circle center section, Crow, Diest, Older Simpson and others. If you Have a Porsche with these camlocks, I can do those as well.
What do you think?, If there is enough interest I can run some off. Pretty inexpensive for a custom touch.