Search results

Hi All, I'm not very prepared as I have been thinking about this for a few months and I just haven't gotten it together so I figured I would just give some basic information for now to see if there is any interest. I have a Yellow 2006 Ford Gt Salvage Title ….$200,000 Has all 3 options Front...

I wasn't driving in the rain boys but I decided to turn the wipers on and the only selection that actually started the motor was when I switched it to High speed.

So I take my first ride of the year..reach over to turn up the blower on the control knob and it just spins around and around. Blower will not turn on and as I spin the knob left or right it appears very smooth (it does pull up now a bit), not even a bumpy spot. The good news is she ran like a...

Went to my first cruise night of the year and ran into a Red one next to me in picture. First one I have seen in a long time!

Guys some of you may remember I pulled the front clip last year to replace a refrigerant line..after completing the install I realized my front drivers turn signal stopped working. I'm positive it worked when I tested it just before I closed up the wheel well...It has not worked since as I just...

Yellow engine light is on so I did a scan and got a code of PO442 "EVAP Emission Control Sytem Leak (small)" Is this my darn gas scap again??

I'm looking for the original car cover and bag for my FordGT....I did find the original bag on ebay for $85.00

When you buy a new battery...say a Sears Platinum Part # 22850080 Platinum 75/86dt CSA 290742. Do you turn in the original core with the GT Logo or do you keep it?

I pulled the GT apart to replace a AC hose, I had to return the hose to get another one so two weeks later and now I forgot how to put together the mess inside the passenger fender! Any pictures would be great! Another lesson learned from the forum....Take Pictures before you tear it down while...

Thought you may enjoy these. I know this is peanuts for Shadowman and the boys but this was my first tear down...not easy!

I could sure use a picture looking down on the hose routing around where you would hook up a suction line gauge for the AC As soon as I figure out how to down size pictures I will post a few

Im trying to figure out how to add pictures...Also Im getting ready to remove the front clip so I can change the condensor AC line...its going to be a bear!! This picture sure is small!

Guys, I have leak in my AC system and I just found it. If you have a picture from a manual with part number that would be great. Its the high side hose that ties into the upper evaporator coil, from there it heads down one ft and towards the firewall, I noticed just past where you would connect...

Has anyone had any problems with there AC system? This morning it was working fine on my way to a car show...after walking around a parking lot in 92 degree heat for two hours couldnt wait for my ride home with cool air blowing on me...all I got was 100 degree vent air blowing on me how...

Last night I went to a "Cruse Night"....there were hundreds of people there, they were flocking around my GT I almost felt famous! It would have been helpful to have some sort of reading material for everyone to read so I'm thinking of a one page plaque with 10 or 15 bullet points describing the...

Guys, please let me know if anyone is already ahead of us on this. I have a good friend that is a expert on guages/electronics, our first problem was we didn't know how to get into the inside of these guages without bending the trim ring. I just received this email below from Scott so he is...

I'm in need of the part number for a Y connector that feeds the breather on the fuel filler neck. I would like to call Ford tomorrow and I'm thinking they wont know what Im taking about. Thanks!

Well I was on my way to repairing my fuel filler neck just like Pro GT Driver did. So far I tore up my hands and I almost tore up the paint and aluminum on the fender when removing the wheel well shroud, I wasn't sure if I should scoop out the wheel well from the top or the bottom..I ended up...

Have any of you repaired or attempted to repair the gauges? If so let me know because I may be wasting my time if its already been perfected. I could really use a gauge that has already been taken apart and not worth rebuilding, I'm working on tooling to remove the silver metal ring around the...

Where do you guys get those numbered decals from? Are they made for the Ford GT?