Recent content by richardhead

Hello All...Looking for a new or unblemished reasonably priced front optional BBS forged wheel. My 2 year-old grandson tipped over while I was detailing a caliper, and it went face down on the pavement! Or, any recommendations on an EXCELLENT refinisher? Also, looking for the metal portion of a...

Thanks for the heads up on the hoses! Another issue has been with the A/C compressor clutch failing. Check this also.

What "automatic on" feature? Mine don't turn on automatically.

Go to your local hardware store and match one up from the small parts drawers.

Is there any kind of alignment tool/gage needed with this installation? If so, does it come with the shifter?

Alex...can I use these to raise the rear end of the car by approximately 1 inch? Thanks....

Hello, Everyone… There has been some discussion on the forum regarding the intermittent operation or failure of one or both of the two front turn signal bulbs. The basic thrust is how to access the units for replacement, but it turns out there are actually a number of things to attend to when...

Doug Rippie tried reverse coolant flowing on an early ZR-1 at LeMans, and it was a disaster. The engine and system had to be designed for reverse cooling from the get-go, it was determined after consulting with the "real" design engineers. Motors not designed with this flow direction in mind may...

Thanks for the kind words, Empty Pockets. I have also used this material, in varying sizes, for years to protect the leading painted edges of hoods and other seams on my metal cars from rock chips and bug hits. It works great. It also works well on the painted top rear edges of hoods to protect...

Earlier, there was a great post on repairing damaged rear diffuser blades with epoxy. However, if it is scrapes a person is worried about, try placing the small diameter flexible door edge protection strip material along the exposed diffuser blade edges. If you should happen to have a slight...

Minnesota Annual License Fee All cars registered prior to September 1, 2009 pay no more than $99.00, as long as the original buyer owns the car, if over three years old (thanks to Jesse Ventura). If you registered a new car for the first time after that date, the license renewals are based...

Chrome Torx Belly Screws/Problem was Open Cluch Coil on Compressor Problem was open clutch coil on compressor. Resolved successfully, but mechanic took about five hours to accomplish since he'd never worked on a GT before $670.00 bill, including part. Anyone know the P/N on the chrome colored...

A/C Compressor Thermal Limiter Is this part serviced separately, and does anyone know the Ford or manufacturer's part number?

Question for GTJOEY... Are you talking about another problem with the air distribution system? Thanks!

"Button" at rear of compressor.... The tech said the clutch coil measured "infinite" and it should measure a few ohms. There was current at the coil connections, but no engagement of the coil so the tech said there was an "open" in the coil. Hopefully, that is the problem. We are both just...